- 1 How to make a fence of reeds?
- 2 How to make a fence of reeds
- 3 A fence made of reeds with their hands: beautiful and not expensive
- 3.1 Bulrush - properties, where to find and how to collect
- 3.2 the base assembly and installation of the stems
- 3.2.1 Comments: A fence made of reeds with their hands: beautiful and not expensive
- 3.2.2 new articles
- 3.2.3 The sanding frame: select Tools
- 3.2.4 Installation of entrance metal doors with their hands
- 3.2.5 How to put brickwork: tricks and tips
- 3.2.6 How to make decorative plaster yourself
- 3.2.7 Biofilter septic tank for their own hands: why pay more?
- 3.2.8 Advice on how to make a decorative plaster with your hands, so that it turned out high-quality and durable
- 3.2.9 What is the level of soil freezing and how to define it
- 3.2.10 How to glue the mirror to the wall: a note on the handyman
- 3.2.11 The outer slopes of plastic windows: why do they need
- 3.2.12 How to concrete yard: the choice of instruments and materials, features and tips
- 3.2.13 The correct calculation Ondulina on the roof: a few tips
How to make a fence of reeds?
I've heard that you can make an interesting sampling of simple cane. I would like to learn the secrets of technology.
The technology depends on the design.
Possible to make a large countertop, and if you do not, just use a large sheet of particle board or boards. Cut the reeds better starting in August and autumn. Cut the cane, and leave it to dry until spring. After the strip it leaves. Spread twigs on the table top layer of 10 cm or more, and Lay mixed type jacks bottom head, in such a case that it does not turn in the one side thickly in other thin. And sew wire or strong thread. An illustrative example of the firmware you are always close at hand - look at the broom.
In the end, that's to receive such "maty9quot;
Such blanks can be made of different lengths.
You can also attach them to a wooden frame and make, for example, that's so cute zabochik.
or is a simpler
Weave the same here such zabochik in layer one Kamyshinke not advise too delicate work, it's not bamboo.
In general, you can use different types of weaving.
For example like this, but I would have preferred this type of rod or rods from the bushes or Dere. more firmly.
And if you connect the imagination in the weaving, and the like that you can try. Perepletkam schemes can borrow and fences made of twigs, sticks.
In our region, you can often see the fences of reeds for pens made as follows: on wooden pillars support slats nailed on both sides in two to three rows and vertically in the space between the slats simply insert the reeds. But you can horizontally like this
and after this you can and clay smear, then, and turn wall or fence wall.
For gardens, cottages, beds can be made like this weaving, looking at the picture once the technology is clear.
What is special technology for this case no, you just enough to survive than his cane and mow. One to deal with such a difficult need an assistant, then it is necessary to build a special machine for weaving reed mats and mats from here and you'll do the fence.
How to make a fence of reeds
What will it take for the manufacture of a fence of reeds?
First of all, he needed a cane. Or it can prepare yourself, or bring to this process hired labor. Reed has the ability to gradually win back water areas, so a sharp reeds have no problem even on lakes and marshes, which are privately owned. Best period workpiece feed - the end of the summer or early autumn. The cut cane is cleaned of leaves and laid out to dry in the shed until spring.
For knitting fabrics made of cane will need a table-workbench. It is important that it should be not less than 2 m, width - slightly more than the planned width of the mat. The table must be put together from flat boards, between which is left a gap thickness, such that they freely passed binding wire, laid in 2-3 layers.
The optimal size of the mat of reeds - 2.1 m, thickness - 10 cm. After the start of the production of paintings hang there rather quickly, and knitting one fence section takes less than 5 minutes.
Bulrush bunches of 15-20 cm in girth spread on a table-workbench. It is important that all the bars have the same length. To beam is the same size on both their sides, half the stems are placed in one side of the butt end, half - the other. This method will allow the sheaf of reeds be uniform throughout its length.
For matings beams used either binding wire or solid nylon strand. After the bundles are stacked on the table, in the hole between the first and second boards push wire cover its bottom beam lying at the edge, and tightened knot. Then repeat the operation. Next, go to the link the next batch of reeds. This continues for as long as there will not be ready the whole mat.
Finished cloth is attached to the pre-set in the ground with wooden bars. To do this, use the same binding wire. To fence bulrush not spoiled rodents, stalks thick is pretreated with a solution of slaked lime. Boards covered impregnated, within which are antiseptics.
A fence made of reeds with their hands: beautiful and not expensive
Fence - a part of the plot, which both protects it and is part of the landscape.
The construction of the fence with their hands out of the reeds can be done in two ways - either want to do everything possible cheaply from scrap materials, or want something in a folk style that did not seem to have already become bored of corrugated fences and mesh-netting.
Bulrush - properties, where to find and how to collect
Reeds - a plant that grows along the banks of rivers and lakes, in swamps, on the beach or in the water in shallow coastal areas. This name mistakenly called cane, which have in mind when they want to build a fence of reeds with their hands. This rush grows in drier areas and is not suitable for construction.
Mistakenly called cattail reeds well. Cattail has on vershinku pineal stalk, which comprises a plurality of seeds, equipped with tips of feather as dandelion. Cattail much denser, heavier, has a thick stem and leaves. For the construction it is also less suitable than an ordinary cane.
If you're not sure that should be used for the construction of a fence made of reeds with their hands, a photo suitable plants below.
Most likely, it is in your area. Look at the banks of reservoirs, and if not found nearby - it is likely that and build from it makes no sense if you have to carry it from afar. The whole point of cheaper construction of improvised materials lost.
Reed (aka bulrush) is a flammable material, but not very strongly support combustion. Hardest burn panicle - they main source of danger. Stems contain significant amounts of calcium and minerals, and even in a dry state not strongly illuminated. In the old roofs of the houses were made of straw or reed, reed burning less frequently and were safer.
Fence of reeds
However, if you want to fence stood for longer and did not create a fire hazard, it must be treated with flame retardants. Most of these compounds are also effective against the formation of mold, bacteria that infect stems insects. By the way, cane insects are not very fond of, but rodents can cause trouble - for them it is quite edible.
The treatment can be carried out and to the construction, but it is much easier to perform processing after the erection of the fence - so much easier to cover the stems of brush or roller, and not have to worry about the allocation of a special place for the coating and drying.
An alternative method of treatment - pouring. Stems are laid on some not based absorbent layer 5-10 cm and sprinkled from the watering composition against combustion. When they are well soaked, they are harvested and put out to dry.
Before you build a fence of reeds with their hands on the fire-retardant treatment of a master-class will not be superfluous. Consult with experienced people, whether the treatment is effective, which make the best use and how to prepare them - they are usually sold in the form of concentrates.
the base assembly and installation of the stems
Evidence to fence can not be too strong. The fact is that a cane (cane) - one of the lightest construction materials that can be imagined. It has a hollow stem and a very small share. The total weight of the fence will be less than wooden of glazing beads.
After installing the poles make the foundation on which will stand the stems. Uses two technologies - a traditional fence on poles or trellis wire or ground in the form of chain-link fencing, with very long strides.
When using such a netting is needed, in which the cell width will be about 10 cm. Its tensioned as usual, placing the pillars every 2-3 meters. One can use a regular grid with a mesh construction 10 cm Then it vdevayut cane stalks, alternating -. Give up one base, the other - downwards. Thus there is a space filling evenly over the entire height of the fence. Trying to do an insert at the same height, carefully align the top. If something did not work - you can then simply cut the top of one line after the assembly of the fence.
The original fence with door
Advantages of such a structure - the small sampling transparency and a large rigidity, it is difficult to pull the stalks of the fence.
- Required to put poles often enough, since netting in rare post will sag, the more rare weave. To put the poles less often, it is necessary to use additional wire trellis, and then they put on netting.
- The second drawback - the need to spend a lot of time and effort to vdevat stems in netting. Given that the fence them out quite a lot of time on the job will go well enough.
It is much more practical than using netting weave the stems horizontally - as in classic the fence. In this case, a rigidity of the fence with vertical pressure-sensitive valves stems play a role for the netting, you can put less supporting columns and additional wire trellis is not required. However, this would require weaving experience.
If you have a skill in a wicker basket - it is useful, otherwise there will be permanent distortions when weaving height of the fence. The main drawback of such a weaving - will require even more time, and the ends of the stems will hang around in and out, they will have to then carefully break off or bite.
The second option - a classic fence. Columns in this set less often, they nailed the pole at approximately equidistant parallel to the ground. Poles should be at least three, preferably five pieces to make fence height of 1.5-2 m. Their number must be odd. Instead, the poles may be used trellis wire - wire should be taut with tension devices and firmly attached.
When mounting stems inserted vertically between poles, twisting them. When weaving goes alternation - stalk braided to one side, the other - the other, as in a wicker basket. Alternate as upper and lower sides of the stem, as in the braiding-on grid fence netting. This type of weaving done much faster - no need to insert the stem from the top down, you can start it from the side and then twisting the entire length with poles or trellises.
How to make your own fence of reeds - Video:
Found an error? Select it and click Ctrl + Enter, to let us know.
Comments: A fence made of reeds with their hands: beautiful and not expensive
In truth, more than 25 years living in this world and the first time I learned that you can make such a beauty of their own hands. Near the small cottage in the countryside. Video and article pretty simple. But who encountered in practice and might have something to say?
Very best fence! We have faced the problem of fences between neighbors because that was quite in a deplorable state. Consider this option. And the wallet beats and neighbors make.
As the fence from the street, of course, will not work, but the fence between neighbors is just the thing. You will need to try to do, next to the cottage just a lake, where a lot of reeds.
The sanding frame: select Tools
The sheathing wooden house outside cheap, beautiful and durable
How to put brickwork: tricks and tips
Bath on black with his hands: the advantages and disadvantages
How to glue the linoleum between them: practical advice
Installation of entrance metal doors with their hands
How to put brickwork: tricks and tips
How to make decorative plaster yourself
Biofilter septic tank for their own hands: why pay more?
Advice on how to make a decorative plaster with your hands, so that it turned out high-quality and durable
What is the level of soil freezing and how to define it
How to glue the mirror to the wall: a note on the handyman
The outer slopes of plastic windows: why do they need
How to concrete yard: the choice of instruments and materials, features and tips
The correct calculation Ondulina on the roof: a few tips
Copyright © 2015 - 2016 All rights reserved.